Loading...
 

SW4STM32 and SW4Linux fully supports the STM32MP1 asymmetric multicore Cortex/A7+M4 MPUs

   With System Workbench for Linux, Embedded Linux on the STM32MP1 family of MPUs from ST was never as simple to build and maintain, even for newcomers in the Linux world. And, if you install System Workbench for Linux in System Workbench for STM32 you can seamlessly develop and debug asymmetric applications running partly on Linux, partly on the Cortex-M4.
You can get more information from the ac6-tools website and download (registration required) various documents highlighting:

System Workbench for STM32

Forum List Topic List

You are viewing a reply to B-L072Z-LRWAN1 StdPeriph not possible to select  

B-L072Z-LRWAN1 StdPeriph not possible to select

Posted by knsingh@qmaxsys.com on 2017-03-25 06:56

Hi,
I have newly purchased B-L072Z-LRWAN1development kit and trying to change the orginal firmware with master/slave configuration. I am using iar Arm for comipiling the software available in I-Cube. My issue is i am not able to program the kit. I am trying to program using on-board ST-Link. IAR skips detecting target and it shows like the device has been programmed even when kit is not connected to the target. All the time original ping-pong firmware only running. Thanks.

Reads: 1114
Link