Loading...
 

SW4STM32 and SW4Linux fully supports the STM32MP1 asymmetric multicore Cortex/A7+M4 MPUs

   With System Workbench for Linux, Embedded Linux on the STM32MP1 family of MPUs from ST was never as simple to build and maintain, even for newcomers in the Linux world. And, if you install System Workbench for Linux in System Workbench for STM32 you can seamlessly develop and debug asymmetric applications running partly on Linux, partly on the Cortex-M4.
You can get more information from the ac6-tools website and download (registration required) various documents highlighting:

System Workbench for STM32

Forum List Topic List

You are viewing a reply to Programming in pure assembler  

Programming in pure assembler

Posted by LaurentL on 2017-03-30 13:24

Hello,

Check the schematic of your appli board, if you can connect the Reset ouput of STLink to the Reset input pin of your STM32F1 device, you don’t need to modify the debug config and manual spec like you did is ok.

Just terminate any debug session or you will have error with LIBUSB...that is still connected to the STLink.

Rgds,
Laurent

Reads: 1799
Link