Posted by LaurentL on 2017-03-27 13:56

Hi,

The vid/pid message is only a warning.
It means you have selected a STLink v2-1 as debug interface instead of a STLINK V2 but that’s not an issue.

In the “debug configurations”, debugger tab, which mode do you have ?
Did you choose an st board like a nucleo F103 or other F1 st board ?
Or you’re using “use local script” and you have a custom board ?
Or you’re using the “Manual spec” mode ?

I don’t see the command that is issued to openocd when you try to Program the chip.
When using menu Target => “Program chip” , you should see the first line with the command text with all arguments given to openocd.exe.

I thought these “blue pills” boards didn’t have a Reset line connected ?
Are you sure it is a Reset line output of stlink for the STM32 reset pin ?
If you had no issue debugging, it means that it’s surely a good reset line.

You can try to use the “Manual Spec” mode (choose stlink V2 and swd) and add just above in openocd options :-c “reset_config none”.
But i am not sure it will be used in menu Target => “Program chip”.

Rgds,
Laurent