STM32F103C8T6 and st-link v2 Debugging error
Hi
The error message in your first post is from the dialog “Problem Occurred” -> detail.
If you select then the console output from openocd you will find something like
... undefined debug reason 7 - target needs reset Error: timed out while waiting for target halted TARGET: stm32f1x.cpu - Not halted in procedure 'reset' in procedure 'ocd_bouncer' ...
This is what happens when i use this local script:
# This is an STM32F1xx-vswr-meter board with a single STM32F103C8Tx chip. # Generated by System Workbench for STM32 source [find interface/stlink-v2.cfg] set WORKAREASIZE 0x5000 transport select "hla_swd" source [find target/stm32f1x_stlink.cfg] # use hardware reset, connect under reset reset_config srst_only srst_nogate
When I use this one it works.
# This is an STM32F103C8T6-mini board with a single STM32F103C8Tx chip. # Generated by System Workbench for STM32 source [find interface/stlink-v2.cfg] set WORKAREASIZE 0x5000 transport select "hla_swd" #source [find target/stm32f1x_stlink.cfg] source [find target/stm32f1x.cfg] # use hardware reset, connect under reset #reset_config srst_only srst_nogate reset_config srst_nogate
Dieter