Posted by nichtgedacht on 2016-03-24 18:42

Hi

The error message in your first post is from the dialog “Problem Occurred” -> detail.
If you select then the console output from openocd you will find something like

...
undefined debug reason 7 - target needs reset
Error: timed out while waiting for target halted
TARGET: stm32f1x.cpu - Not halted
in procedure 'reset' 
in procedure 'ocd_bouncer'
...

This is what happens when i use this local script:

# This is an STM32F1xx-vswr-meter board with a single STM32F103C8Tx chip.
# Generated by System Workbench for STM32

source [find interface/stlink-v2.cfg]

set WORKAREASIZE 0x5000
transport select "hla_swd"


source [find target/stm32f1x_stlink.cfg]

# use hardware reset, connect under reset
reset_config srst_only srst_nogate

When I use this one it works.

# This is an STM32F103C8T6-mini board with a single STM32F103C8Tx chip.
# Generated by System Workbench for STM32

source [find interface/stlink-v2.cfg]

set WORKAREASIZE 0x5000
transport select "hla_swd"

#source [find target/stm32f1x_stlink.cfg]

source [find target/stm32f1x.cfg]


# use hardware reset, connect under reset
#reset_config srst_only srst_nogate
reset_config srst_nogate

Dieter