Error: Whole bank access must start at beginning of bank.
“C:\Ac6\SystemWorkbench\plugins\fr.ac6.mcu.externaltools.openocd.win32_1.20.0.201809060829\tools\openocd\bin\openocd.exe” -f stm32.flash.6366760870852224461.cfg -s “C:\Users\BaskarK\workspace_stm\myblink” -s “C:\Ac6\SystemWorkbench\plugins\fr.ac6.mcu.debug_2.2.0.201807130628\resources\openocd\st_scripts” -c “program Debug/myblink.elf verify exit”
Open On-Chip Debugger 0.10.0-dev-00011-g46c94c8 (2018-09-06-08:52)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
padded zone erase set to 1
adapter_nsrst_delay: 100
adapter speed: 480 kHz
Info : clock speed 480 kHz
Info : STLINK v2.1 JTAG v29 API v2 M18 VID 0x0483 PID 0x374B
Info : using stlink api v2
Info : Target voltage: 3.255446
Info : Stlink adapter speed set to 480 kHz
Info : STM32L476RGTx.cpu: hardware has 6 breakpoints, 4 watchpoints
Info : Stlink adapter speed set to 480 kHz
adapter speed: 480 kHz
target halted due to debug-request, current mode: Thread
xPSR: 0x01000000 pc: 0x1fff6144 msp: 0x200030d0
Info : Stlink adapter speed set to 4000 kHz
adapter speed: 4000 kHz
- Programming Started **
auto erase enabled
Info : Device id = 0x10076415
Info : STM32L4xx flash size is 1024kb, base address is 0x8000000
Info : Erase the padded zone before the write
Error: Whole bank access must start at beginning of bank.
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x20000050 msp: 0x200030d0
Warn : block write succeeded
wrote 6144 bytes from file Debug/myblink.elf in 0.239015s (25.103 KiB/s)
- Programming Finished **
- Verify Started **
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000002e msp: 0x200030d0
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000002e msp: 0x200030d0
verified 4424 bytes in 0.201950s (21.393 KiB/s)
- Verified OK **
shutdown command invoked
21:13:18 Build Finished (took 1s.53ms)
In linker script the program starts at correct location
;){kind=link}