having problem while debugging or running code Nucleo-F767ZI board
I am new to STM32 and Nucleo-F767ZI board
I am facing issue given below. Please help me.
Open On-Chip Debugger 0.10.0-dev-00007-g58350bc-dirty (2018-01-12-12:21)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter_nsrst_delay: 100
adapter speed: 1800 kHz
Info : clock speed 1800 kHz
Info : STLINK v2.1 JTAG v28 API v2 M18 VID 0x0483 PID 0x374B
Info : using stlink api v2
Info : Target voltage: 3.251053
Info : Stlink adapter speed set to 1800 kHz
Info : STM32F767ZITx.cpu: hardware has 8 breakpoints, 4 watchpoints
Info : Stlink adapter speed set to 1800 kHz
adapter speed: 1800 kHz
target halted due to debug-request, current mode: Thread
xPSR: 0x01000000 pc: 0x08001784 msp: 0x20080000
Info : Stlink adapter speed set to 4000 kHz
adapter speed: 4000 kHz
- Programming Started **
auto erase enabled
Info : flash size probed value 2048
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x20000084 msp: 0x20080000
wrote 32768 bytes from file Debug/STM32_uart.elf in 0.660677s (48.435 KiB/s)
- Programming Finished **
- Verify Started **
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000002e msp: 0x20080000
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000002e msp: 0x20080000
verified 2412 bytes in 0.178721s (13.180 KiB/s)
- Verified OK **
- Resetting Target **
Info : Stlink adapter speed set to 1800 kHz
adapter speed: 1800 kHz
shutdown command invoked
;){kind=link}