System Workbench for STM32

Laurent,

thank you very much for your answer. I've already updated the firmware from the following website:

https://my.st.com/content/my_st_com/en/products/embedded-software/development-tool-software/stsw-link007.license%3d1500978085593.html

but it didn't change anything.The STLink from stm32f0 disco is connected to the NRST line, and this should be ok, because as mentioned it's working perfectly with uVision 4. Therefore I think the problem should be in the elf file.

I'm attaching the screenshot of the settings in ac6, where it's obvious that the selected microcontroller is stm32f303vet, apart from that I don't know if the elf file is correct. It's not looking like a text file, it's just showing "chineese" symbols...