System Workbench for STM32

Hi Laurent,

Appreciate the response,
I initially attempted to run SW4STM32 for Mac OS/x using the installer found on this page, which claims to be the latest and greatest version. After downloading and installing, I opened the SW4STM32 application and created a basic Ac6 STM32Discovery Board project, and configured my Debug and Run configurations by double clicking "Ac6 STM32 Debugging", followed by clicking "Run". I then get the print statements posted above in my console log.

I checked for updates, and there were some, so i updated all of them. Tried again, and still no luck. I've checked my Activity Monitor for an existing openocd task that could possibly be running, but I do not see any.

I do only have only one STLink board connected at the moment.

As far as drivers for STLink, I'm not too sure where to find an appropriate driver for Mac OSx 10.12. I've attempted to install stlink using homebrew, and tried to run my configuration again after, yet still the same results.

After these attempts, I uninstalled SW4STM32 and tried to setup the workbench through eclipse instead. After installing eclipse, downloading the SW4STM32 plugins through its installer and running my configuration, I still get the same results in my console log.

I'm thinking it could be a driver issue that isn't allowing openocd to connect to my board, although I really have no clue.

Thanks again for your help