Failed to launch debug
Hi Laurent
Thanks for your reply.
I confirmed that:
- STLink utility is stopped
- The Reset line output is connected to the reset of the my custom board processor (is their a simple way to double check? This is the way it is supposed to be, but a bug is always possible! -like PCB trace cut or bad soldering...! Anyway, the STLink utility is working fine so there should be a way to erase and program memory with my current hardware config)
I do not need to reconnect to an already programmed application, at least at the moment, since I will likely reprogram after each debug session. It will effectively be usefull later when the program become more stable.
By the way, the application was developped using CubeMX and then converted from C to C++.
Regards
gerard.