Loading...
 
Skip to main content

System Workbench for STM32

Forum List Topic List

Forums » System Workbench for STM32 » STM32VLDiscovery debug
 
Thread actions
Print this page
  • Print all pages

    • STM32VLDiscovery debug

    Posted by Nevada on 2016-07-09 23:21

    Hi!

    I use the latest Ac6 workbench and an STM32VLDiscovery board. I could set it up (this board has not been supported yet officially), and works fine, but unfortunately the Debug does not work.
    Is it possible to debug with Ac6?

    Reads: 10289
    Posted by Nevada on 2016-07-10 15:23

    The error message is the following:

    "Error in final launch sequence
    Failed to execute MI command:
    -target-select remote localhost:3333

    Error message from debugger back end:
    localhost:3333: The system tried to join a drive to a directory on a joined drive.
    localhost:3333: The system tried to join a drive to a directory on a joined drive."

         Posted by willy_me on 2016-07-10 21:48
    Try running the command manually via a terminal. On Linux I found that openocd was requesting a library that was not installed on my system. But regardless of the cause, running manually should provide you with the information needed to get it going.
    Posted by Nevada on 2016-07-11 10:58

    Dear Pascale,

    Thanks for the reply! My first solution was that I used an F4Discovery board to program the VLDiscovery, but I will check your suggestion!

    Best regards,
    Nevada

         Posted by Nevada on 2016-07-11 11:34
    I realised that the othes suggested method is exatly the same what I use.:)

    Posted by ronu008 on 2016-12-12 21:09

    Hi,

    I'm facing the same problem. I tried many things, but none of them worked for me. Did you get it to debug with AC6? If yes, can you tell me what changes you made to debug settings ? Thanks in advance,.


     
    Collapse/expand modules below