Errors after a clean on CubeF4 examples
When I load any of the examples from STM32Cube_FW_F4_V1.7.0 package, e.g. “STM32Cube_FW_F4_V1.7.0\Projects\STM32F401-Discovery\Examples\GPIO\GPIO_EXTI\SW4STM32”, I’m able to build out of the box but after I do a clean and try to rebuid again, then I get errors when trying to rebuild. I found that if I attempt to rebuild four times, then the fourth time, it works. After each of the first three build attempts, I get three different errors.
Project->Build Project
Errors occured during build.
Errors running builder ‘CDT Builder’ on project ‘STM32F4xx-Nucleo’.
Resource ‘/STM32F4xx-Nucleo/Debug/sources.mk’ does not exist.
Project->Build Project
Errors occured during build.
Errors running builder ‘CDT Builder’ on project ‘STM32F4xx-Nucleo’.
Resource ‘/STM32F4xx-Nucleo/Debug/makefile’ does not exist.
Project->Build Project
Errors occured during build.
Errors running builder ‘CDT Builder’ on project ‘STM32F4xx-Nucleo’.
Resource ‘/STM32F4xx-Nucleo/Debug/object.list’ does not exist.
Project->Build Project
Builds Project Successfully. __
Can you look into this issue and fix in future release?
Thanks,
Joe T