ac6 cannot debug/program stm32F411RE after update .... yet again.
Here is what is shown in the debug console when using automatic:
Unplugged target or STLink already in use or STLink USB driver not installed
Open On-Chip Debugger 0.10.0+dev-00021-g524e8c8 (2019-04-12-08:33)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 2000 kHz
adapter_nsrst_delay: 100
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : clock speed 2000 kHz
Error: libusb_open() failed with LIBUSB_ERROR_ACCESS
Error: open failed (no matching adapter found)
in procedure ‘program’
in procedure ‘init’ called at file “embedded:startup.tcl”, line 495
in procedure ‘ocd_bouncer’
** OpenOCD init failed **
shutdown command invoked