System workbench how to configure openocd debug
We work with DWM3000evb and nRF52840DK board.We followed “Guide_for_example_build” file to run the example codes,and we connect the board with PC using a USB.But we don’t know how to configure the openocd configuration options.We don’t find nrf52.cfg in system workbench project,and don’t know how to select the debug interface.
And when I use “jlink.cfg”,it has the following errors :
Open On-Chip Debugger 0.10.0+dev-00021-g524e8c8 (2019-04-12-08:48)
Licensed under GNU GPL v2
For bug reports, read
OpenOCD: Bug Reporting
Error: The specified debug interface was not found (jlink)
The following debug interfaces are available:
1: ftdi
2: usb_blaster
3: vsllink
4: ulink
5: hla
6: osbdm
7: opendous
8: aice
9: cmsis-dap
10: kitprog
So I should how to build the examples ,and configure the openocd debug configurations .Thanks for helping.