Charger firmware
I guess the problem is with the CYUB3014 setup.
What should I do to make the CYUSB3014 ready for compliance testing?
Should I change the firmware or do something through the FPGA?
This is the information on my board for the CYYSB3014: 1.
1. the firmware is SlaveFIFoSync
2. connected from FIFO interface (GPIF II) to FPGA) (altera) 32bit MCU
The following are the steps of the device TX compliance test.
1. Install the board and download the firmware to CYUSB3014
2, connect the USB connector on the board to the test fixture (KEYVIEW), picture upload