Posted by elivnat70 on 2019-03-14 03:35

I’m trying to run a compiled release on STM32F756 on latest AC6 version .
I get this message
Open On-Chip Debugger 0.10.0-dev-00019-g5352c55 (2019-02-14-15:45)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 4000 kHz
adapter_nsrst_delay: 100
Info : clock speed 4000 kHz
Info : STLINK v2 JTAG v32 API v2 SWIM v7 VID 0x0483 PID 0x3748
Info : vid/pid are not identical: 0x0483/0x374B 0x0483/0x3748
Info : using stlink api v2
Info : Target voltage: 3.085489
Info : Stlink adapter speed set to 4000 kHz
Info : STM32F765IGHx.cpu: hardware has 8 breakpoints, 4 watchpoints
target halted due to debug-request, current mode: Thread
xPSR: 0x01000000 pc: 0xfffffffe msp: 0xfffffffc

• Programming Started **

auto erase enabled
Info : flash size probed value 1024
Info : Padding image section 0 with 488 bytes
wrote 458752 bytes from file Release22/4200.elf in 6.038865s (74.186 KiB/s)

• Programming Finished **
• Verify Started **

target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000002e msp: 0xfffffffc
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000002e msp: 0xfffffffc
verified 250640 bytes in 0.330055s (741.590 KiB/s)

• Verified OK **
• Resetting Target **

shutdown command invoked

The program will not run and on the debug console I get Terminated value 0>opencd.
On the startup of the configuration I have as shown on the attached file.
Any ideas.

Thank you.