Forum: System Workbench for STM32

Installation of Workbench on Mac 10.13.6

Posted by STM32PSBG on 2018-10-30 14:47

Hi there,

I am trying to install the workbench for STM32 on my mac as part of a school project.

However i am unable to do so, i’ve tried everything described on the forums and the website, but nothing works. Can some one provide a detailed instruction on how to do so.


Thank you very much.

Reads: 10773
Link
Posted by tang on 2018-10-30 15:13

Hi,

Here the link to download the latest version of System Workbench for STM32 on MAC OSX : http://www.ac6-tools.com/downloads/SW4STM32/install_sw4stm32_macos_64bits-latest.runQuestion

Open a terminal then go to the download directory
Set the execution rights to the file “install_sw4stm32_macos_64bits-latest.run”

 
chmod 755 install_sw4stm32_macos_64bits-latest.run

Disable the OSX gatekeeper (admin password required) 

xxxxxxxxxx
 
sudo spctl --master-disable

Execute the installer 

xxxxxxxxxx
 
./install_sw4stm32_macos_64bits-latest.run

Set OSX gatekeeper back 

xxxxxxxxxx
 
sudo spctl --master-enable


If, it does not open the installer GUI or if any step failed, please copy us the error message.

Regards,
Kevin

Link
Posted by iparker2 on 2023-06-04 19:52

Hello!
I tried the command lines and I am getting “Bad CPU type in executable”. Here is the full line with my name taken out.
./install_sw4stm32_macos_64bits-latest.run: line 191: /Users/MyNameNoSpaces/Downloads/.jre/Contents/Home/bin/java: Bad CPU type in executable

I am using a new MacBook Air with the M1 chip and Mac Ventura 13.4

Thank you!

Link
Posted by tang on 2023-06-05 09:47

Hi,

Sorry, the MacOS version is not maintained anymore. The M1 and M2 chips are not supported.

Regards,
Kevin.

Link
Posted by iparker2 on 2023-06-06 20:54

Thank you for your response!
I was able to find a solution using Rosetta 2 by downloading it in the Terminal with this command.
softwareupdate --install-rosetta

I hope this helps!

Link
Posted by tang on 2023-06-07 09:27

Hi,

Thank you for sharing your solution! We will add it in the installation steps for MacOS users.

Regards,

Link

Posted by lukelectro on 2019-04-07 16:01

Hi,

just to let you know I found this helpful.

Also, installation on 10.14.3 (Mojave) of sw4stm32 v2.8 succeeded without disabling gatekeeper.
chmod 755 was needed though.

Link

Posted by TSGE on 2020-02-27 01:03

Hello kind People,

Have tried theses steps a few times re-downloading the file and trying again but continue to get “no such file or directory” when I go to execute the file. (Note this does not happen when giving the file execution rights)

Any advice?

Link