Loading...
 

SW4STM32 and SW4Linux fully supports the STM32MP1 asymmetric multicore Cortex/A7+M4 MPUs

   With System Workbench for Linux, Embedded Linux on the STM32MP1 family of MPUs from ST was never as simple to build and maintain, even for newcomers in the Linux world.
And, if you install System Workbench for Linux in System Workbench for STM32 you can seamlessly develop and debug asymmetric applications running partly on Linux, partly on the Cortex-M4.
You can get more information from the ac6-tools website and download two short videos (registration required) highlighting:

System Workbench for STM32

Forum List Topic List

You are viewing a reply to Nucleo board can't program or debug after upgrade.  

Nucleo board can't program or debug after upgrade.

Posted by realb on 2018-07-21 15:44

Similar problem here.

After accepting today the latest updates, I cannot anymore program or debug a custom made board based on STM32F732RET.

The log file is attached. As you can notice, libusb_get_device_list() fails with the error code LIBUSB_ERROR_OTHER.

The hardware connection is ok, the ST-LINK utility is able to recognize the st-link v2 programmer and to read/write the FLASH memory.

The firmware on the programmer has been upgraded to the latest version (V2.J31.S7), I connected the programmer also to slower USB 2.0 ports.

Any help would be very appreciated.

Regards,
Alberto

openocd.log (29.61 Kb)
Reads: 664
Link