Not able to flash Nucleo32 stm32l432kcu6
Hi,
Seeing the text, i assume the flash has been programmed :
◦ Programming Started **
◦ Programming Finished **
◦ Verify Started **
◦ Verified OK **
◦ Resetting Target **
The error messages (LIBUSB_ERROR_NOT_SUPPORTED) can be seen on Win 10 but i don’t know why.
But anyway, don’t stop at these messages, they are more like warnings, the flash has been programmed and verified.
You can check the flash content with STM32 STLink Utility tool or STM32 Cube programmer.
Rgds,
Laurent