Solving OpenOCD Debugging/Uploading problem
Hi, I just want to share a solution to a possible problem. I created a custom board based on STM32F407 MCU. When trying to upload firmware or debug there was OpenOCD error. I solved it by changing this configuration file include in the ProjectName.cfg file:
interface/stlink-v2-1.cfg
to this:
interface/stlink-v2.cfg
because my ST-Link device on STM32F4-Discovery is v2. Newer Nucleo boards have ST-Link v2.1 in which case no correction is needed.
I would suggest OpenSTM32 developers to have a setting in the GUI to select the ST-Link version.
Thanks.