Loading...
 
Skip to main content

System Workbench for STM32

Forum List Topic List

Forums » System Workbench for STM32 » Can't use debugger on MavOS X » Can't use debugger on MavOS X
You are viewing a reply to Can't use debugger on MavOS X
 
Thread actions
Print this page
  • Print all pages

    • Can't use debugger on MavOS X

    Posted by doraemon on 2017-09-10 13:23

    Hello!

    Sorry for the delay.
    My OSX is the latest one. It says MacOS Sierra Version 10.12.6

    LaurentL wrote:

    First, you can update the stlink firmware to the latest version (V2 J28).
    You can find the stlink firmware upgrade on ST website.

    Done, but no change.

    LaurentL wrote:

    Then, it seems you didn't connect the Vdd mcu to the stlink since the log says target voltage measured at 0V.
    Maybe not important but if you can connect it, it's better.

    I don't think it's important, and I even think it would do more harm than good. My board (custom) is powered
    externally. Beside this, it works pedfectly with IAR, so I think it's a software problem.

    LaurentL wrote:
    Did you connect the STlink reset line to the mcu reset pin ?

    Yes.

    LaurentL wrote:

    The STlink is from a nucleo board ?
    If yes, did you remove the 2 jumper for Nucleo mode ?

    Yes, its' a STLink, but it's cut-off from the board in order to make it smaller.

    LaurentL wrote:
    How did you create the project ?

    With my fingers...
    Joke aside: I have made it with CubeMX. It used to work fine untile I installed some
    upgrades to the IDE.

    LaurentL wrote:
    Maybe you can try a simple project without interrupts first.

    Do you mean that interrupts can cause problems to the software? In this case, it would
    certainly be a big issue for me because I can't program without interrupts.

    Thanks,

    Dora.

    Reads: 1389