Forum: System Workbench for STM32

Posted by LaurentL on 2017-07-25 10:21

Hi,

First, update the stlink firmware, v19 is quite old...

Did you connect the reset line from STlink to target F303 reset input ?

Are you sure the elf file is correct ?
because these lines in log seem suspect :
******
Warn : no flash bank found for address 0
Warn : no flash bank found for address 448b0
wrote 0 bytes from file Debug/emct_display_ac6.elf in 0.119000s (0.000 KiB/s)
*******
Was it created for a F303 device ?