Error Debugging
Updated open OCD but still the same for debug.
In fact in RUN mode the log file says: ** Unable to reset target ** shutdown command invoked.
Tried as well to modify the version of st-link in the debug config from st link V2.1 to V2 but still the same...ST-link file updated as well.
I do not have trouble with the nucleo F411RE board.
but It chooses by default a default script for debug device : nucleo_f411re.cfg
https://i58.servimg.com/u/f58/14/75/42/81/captur10.jpg
On the contrary when using the STM32F103 board there is no default script evalable and I check in Manual spec the st link V2 or V2.1 with no result.
I tried this board with arduino and it works so the board is ok.
Thanks for your help.