Target connection fails with "Cannot identify target as a stm32x" (although STM32L053 works)
Hello,
About the log text, i can see you’re using the menu Target => Erase or Program, why don’t you use the debug button ?
For the Nucleo used as a Nucleo, it should give you the vdd voltage.
Do you have the CN2 ON for Nucleo usage.
JP6 ON mandatory to have VDD on target cpu.
JP5 on U5V (not E5V).
For the schematic, i would connect VSSA to GND and VDDA to VDD.
I would remove the resistor of 1K pull-up on Reset (STM32 has an internal reset of 50K i think) or change value to 10K at least.
For the SWD connections, can you tell which one you made ?
STlink CN4 has 6 pins:
Pin 1 is STlink VDD input to measure : To connect to your VDD at 3.3V
Pin 2 is SWCLK
Pin 3 is GND
Pin 4 is SWDIO
Pin 5 is N_Reset
Pin 6 is SWO (not needed for debug)
Then, you should have removed the 2 Jumpers on CN2 for STLink usage.
Maybe remove JP6 to not have VDD on MCU on Nucleo.
Rgds,
Laurent
;){kind=link}