Loading...
 
Skip to main content

System Workbench for STM32

Forum List Topic List

 
Thread actions
Print this page
  • Print all pages

    • Multitude of HAL_RCC not resolved errors

    Posted by dnbharrin on 2016-11-18 18:43

    Vetch,
    Thanks for responding.

    I followed your advice. The hal_conf.h file has HAL_RCC_MODULE_ENABLED defined.

    I think I found the problem. The default in CubeMX Project >> Settings >> Project >> Toolchain / IDE was set to EWARM instead of STM32

    I then ran build in STM32 and got no errors in the Problems window. This was run with Project Properties Build Type set to External Build. I do not know what External and Internal Build means. If I use Internal Build I get the Error 2 message in the Problems Window.

    However, with no errors in Problems Window using External Build, it still will not run. I get this error message:

    Error starting process.
    Cannot run program "C:\STM32 Nucleo Projects\Test1_ST_20161117\SW4STM32\Test1_ST_20161117\Debug\Test1_ST_20161117.elf": Launching failed
    Cannot run program "C:\STM32 Nucleo Projects\Test1_ST_20161117\SW4STM32\Test1_ST_20161117\Debug\Test1_ST_20161117.elf": Launching failed
    Cannot run program "C:\STM32 Nucleo Projects\Test1_ST_20161117\SW4STM32\Test1_ST_20161117\Debug\Test1_ST_20161117.elf": Launching failed

    Is this just because I do not have any code in the users code sections? or is it something else?

    Thanks again,

    Dave

    Reads: 3144
    Posted by dnbharrin on 2016-11-18 19:35

    I included a simple toggle of one IO pin and I still get the same error when attempting to run the project. The program in Main.c is this:

    while (1)
    {
    /* USER CODE END WHILE */
    HAL_GPIO_TogglePin(GPIOC, GPIO_PIN_0);
    /* Insert delay 100 ms */
    HAL_Delay(200);
    /* USER CODE BEGIN 3 */

    }

    no errors during complile


     
    Collapse/expand modules below