failed to start debuuging on STM32F0308-Discovery board
Another update regarding erase and programming operation on STM32F0308-Discovery.
Run ST-Link Utility on Windows 10, the erase and programming operation all work fine. No problem.
Still on Windows 10, from cpp-neon Eclipse CDT with all Ac6 plugin install and updated, the Target => Erase chip failed.
The information as below
Open On-Chip Debugger 0.10.0-dev-00272-gf17dc4a (2016-10-10-09:38)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Info : auto-selecting first available session transport “hla_swd”. To override use ‘transport select ‘.
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 1000 kHz
adapter_nsrst_delay: 100
srst_only separate srst_nogate srst_open_drain connect_assert_srst
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : Unable to match requested speed 1000 kHz, using 950 kHz
Info : Unable to match requested speed 1000 kHz, using 950 kHz
Info : clock speed 950 kHz
Info : STLINK v2 JTAG v28 API v2 SWIM v0 VID 0x0483 PID 0x3748
Info : using stlink api v2
Info : Target voltage: 2.917955
Info : stm32f0x.cpu: hardware has 4 breakpoints, 2 watchpoints
Info : Unable to match requested speed 1000 kHz, using 950 kHz
Info : Unable to match requested speed 1000 kHz, using 950 kHz
adapter speed: 950 kHz
Error: timed out while waiting for target halted
TARGET: stm32f0x.cpu - Not halted
in procedure ‘reset’
in procedure ‘ocd_bouncer’
20:11:22 Build Finished (took 1s.268ms)