STLink programming/debug problem
Windows, stlink utility detects board via
VID/PID 0x0483 0x3748 for ST-Link/V2
NOTE: This is a chinese clone
Program, erase and checksum via GUI no problem. Selecting .bin file from a STM32 workbench built test project works.
------------
Back to STM32 work bench. Using “install_sw4stm32_win_32bits-v1.8.exe” bundled eclipse edition.
All I get on run is:
Cannot debug or run using default scripts:
Open On-Chip Debugger 0.10.0-dev-00267-g884c33c (2016-03-16-12:22)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 1000 kHz
adapter_nsrst_delay: 100
srst_only separate srst_nogate srst_open_drain connect_assert_srst
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : Unable to match requested speed 1000 kHz, using 950 kHz
Info : Unable to match requested speed 1000 kHz, using 950 kHz
Info : clock speed 950 kHz
Error: read version failed
in procedure ‘init’
in procedure ‘ocd_bouncer’