STLINK v2 reset not working, unable to program/debug
UPDATE: DON’T BUY A $2,- ST LINK V2 from aliexpress.
Afther spending a full day trying to make my debugger work (learning some openocd in the progress) I gave up
I noticed that the clock speed can’t be 1000KHZ and it switches to 950Khz and thought that’s odd. I began to suspect my $2,00 ST Link V2 wasn’t the best buy. So I took my debugger apart and found out it was based on a STM32F101. My stm32F4 discovery board uses a STM32F103 chip as programmer instead (double the clock speed 36mhz >> 72mhz). So i switched to my discovery board as programmer/debugger it worked without a hitch (no modification needed to the default configuration were needed).
;){kind=link}