Some (beginners) problems with OpenSTM32
Ok, debugging works so far...thanks a lot!
Now there is one problem left, when i try to program the chip: (target->prorgramm chip)
05:06:02 **** Programing project test1 on chip ****
/home/harry/.eclipse/org.eclipse.platform_4.5.2_1473617060_linux_gtk_x86_64/plugins/fr.ac6.mcu.externaltools.openocd.linux64_1.8.0.201603291120/tools/openocd/bin/openocd -f test1.cfg -s /home/harry/workspace/ARM/test1/SW4STM32/test1 -s /opt/eclipse/../../home/harry/.eclipse/org.eclipse.platform_4.5.2_1473617060_linux_gtk_x86_64/plugins/fr.ac6.mcu.debug_1.8.0.201603291114/resources/openocd/scripts -c “program Debug/test1.elf verify exit”
Open On-Chip Debugger 0.10.0-dev-00265-g12ff60f (2016-03-11-12:04)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 1000 kHz
adapter_nsrst_delay: 100
srst_only separate srst_nogate srst_open_drain connect_assert_srst
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : Unable to match requested speed 1000 kHz, using 950 kHz
Info : Unable to match requested speed 1000 kHz, using 950 kHz
Info : clock speed 950 kHz
in procedure ‘program’
in procedure ‘init’ called at file “embedded:startup.tcl”, line 473
in procedure ‘ocd_bouncer’
- OpenOCD init failed **
shutdown command invoked
I’ve used the board-definition i created when initialy launched openocd.
What’s going wrong?
I think, it has to do with the reset-handling....any idea?
Harry
;){kind=link}