Forum: System Workbench for STM32

Does Debugging a CubeMX Project work out of the box?

Posted by BenoitHanridge on 2016-03-25 14:17

Hi All,

Does Debugging a CubeMX Project work out of the box?

Debug never worked on my WS4STM32 since its installation whatever CubeMX Project I start from. It gives me all sorts of reasons not to work. Did I mess up since installation of the SW4STM32 and should Debug have worked out of the box?

I have a STM32F103C8T6 on a J-Link mini board which flashes and works ok.

I upload my projects via a J-Link on an STM32F407VGT Discovery with board appropriatly removed SB11 smd (reset) and positioned pcb jumpers.

J-LINK wires used are SWD: 1) Clock, 2) Data and 3) Reset.

Of course now I need to see what’s happening in detail to values and want to use the Debug feature of Eclipse.

Regards,
Ben

Reads: 9273
Link
Posted by tarek bouchkati on 2016-03-25 14:53 Tunisia

Default openocd scripts for ST boards, uses ST-Link as debug probe. So you need to customize your openocd script :

example (to be used as local script)

stm32f4disco+jlink.cfg
​x
 
# This is an STM32F4 discovery board with a single STM32F407VGT6 chip.
# http://www.st.com/internet/evalboard/product/252419.jsp
​
source [find interface/jlink.cfg]
​
transport select jtag
​
source [find target/stm32f4x.cfg]
​
# use hardware reset, connect under reset
reset_config srst_only srst_nogate


EDIT : for further information @see this topicQuestion

Regards,
Tarek

Link