System Workbench for STM32

Hi Brano,

I believe you when you said that STM32F4 Discovery board has a STLINK-V2 and that STLINK-V2 does not
support Virtual Com over STLINK. Before I answered to HugoARA telling to check if from the STLINK block
of him STM32F4 Discovery board there are some UART signals that come out and go into STM32F4 MCU,
but I do not pay attention to your previous post when you said that only STLIN-V2.1 support Virtual COM and
that STLINK-V2 does not.
So if there is not a way to upgrade the STLINK from V2 to V2.1 (I think this operation need to be done if
possible on both the side - those firmware on Discovery board and those software on PC for the Win USB
device driver part) no other way to run UART communication over ST-LINK will be possible (also if a hardware
link between the STLINK block and the MCU is presente on the Discovery board).

Scrat