Run and Debug Configurations don't work
After a full re-install, System Workbecnh is still a broken application.
The following error message doesn't actually say what is wrong.
Open On-Chip Debugger 0.9.0-dev-00415-g2d4ae3f-dirty (2015-06-12-17:54)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 2000 kHz
adapter_nsrst_delay: 100
none separate
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : clock speed 1800 kHz
Info : STLINK v2 JTAG v24 API v2 SWIM v11 VID 0x0483 PID 0x374B
Info : using stlink api v2
Info : Target voltage: 3.255446
Info : STM32F446.cpu: hardware has 6 breakpoints, 4 watchpoints
target state: halted
target halted due to debug-request, current mode: Thread
xPSR: 0x01000000 pc: 0x080001e0 msp: 0x20020000
- Programming Started **
auto erase enabled
Error: couldn't open Lidar
- Programming Failed **
shutdown command invoked
So am I just floating on my own here?
There is very little I can do with this information. Is anyone else seeing this?