Debugging setup issue on ST discovery and eval board
Hi All,
I am a new user for SW4STM32 and struggling under debug configuration now.
Whenever I started debug, I can see the message below on console window and
dialog box saying “Program file does not exist”
“Open On-Chip Debugger 0.9.0-dev-00415-g2d4ae3f-dirty (2015-04-22-11:10)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Info : auto-selecting first available session transport “hla_swd”. To override use ‘transport select ‘.
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 2000 kHz
adapter_nsrst_delay: 100
none separate
srst_only separate srst_nogate srst_open_drain connect_deassert_srst
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : clock speed 1800 kHz
Info : STLINK v2 JTAG v21 API v2 SWIM v0 VID 0x0483 PID 0x3748
Info : using stlink api v2
Info : Target voltage: 2.852883
Info : stm32f4x.cpu: hardware has 6 breakpoints, 4 watchpoints”
I have tested this with STM32f429I-discovery and STM32f429_eval board and SW packages are
stm32cubef4 v1.6.0. and stm32cubef4 v1.7.0. The results were always same as above.
I just configured “Debug configuration” with default settings. Anybody can help me resolve this issue?
Actually, I was expecting there isn’t any trouble because I was using STMicroelecronics boards and SW packages.
ST-Link looks fine because I can download the binary file compiled by SW4STM32 using ST-Link utility.
Thank you in advance.