Connection ST-LINK/V2 and STM32L433RCT
Hi,
I have System Workbench for STM32 and ST-LINK/V2 ISOL and I want to program a STM32L433RCT6 microcontroller.
I create an “Ac6 STM32 Debugging” session and I launch it. I didn’t change anything in the session; I used the suggested settings.
I turn on the power (3.3V) and the board and I launch the debug session.
When I launch the debug, I found a problem and I cannot connect to the microcontroller.
Here the error window:
Wrong device detected
Open On-Chip Debugger 0.10.0-dev-00007-g58350bc-dirty (2018-01-12-12:21)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
padded zone erase set to 1
adapter_nsrst_delay: 100
adapter speed: 480 kHz
Info : tcl server disabled
Info : telnet server disabled
Info : clock speed 480 kHz
Info : STLINK v2 JTAG v28 API v2 SWIM v6 VID 0x0483 PID 0x3748
Info : vid/pid are not identical: 0x0483/0x374B 0x0483/0x3748
Info : using stlink api v2
Info : Target voltage: 3.257031
Error: init mode failed (unable to connect to the target)
in procedure ‘init’
in procedure ‘ocd_bouncer’
Here the console window:
Open On-Chip Debugger 0.10.0-dev-00007-g58350bc-dirty (2018-01-12-12:21)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
padded zone erase set to 1
adapter_nsrst_delay: 100
adapter speed: 480 kHz
Info : tcl server disabled
Info : telnet server disabled
Info : clock speed 480 kHz
Info : STLINK v2 JTAG v28 API v2 SWIM v6 VID 0x0483 PID 0x3748
Info : vid/pid are not identical: 0x0483/0x374B 0x0483/0x3748
Info : using stlink api v2
Info : Target voltage: 3.257031
Error: init mode failed (unable to connect to the target)
in procedure ‘init’
in procedure ‘ocd_bouncer’
Do you have any suggestion?
Best regards,
Andrea Cavazzoni
;){kind=link}