Problem Debugging: Nucleo-F410RB
OS: Windows 10
I am trying to run a project I generated using STM32CubeMX for the STM32F410RBTx processor. I am getting the following output when trying to run it. I am using the STLink V2-1 debugger integrated with the Nucleo board. I tried updating the firmware on the Nucleo board and also tried un / reinstalling the ST-Link USB driver with no luck. Previously, I was able to create and run other projects using CubeMX for the Nucleo-F302R8 board. Aside from the console output below, I also get a message box from Eclipse saying “OpenOCD child process termination. Wrong Device Detected”.
Any ideas? Thanks!
Open On-Chip Debugger 0.10.0-dev-00275-gd486ac2-dirty (2017-03-06-15:22)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 2000 kHz
adapter_nsrst_delay: 100
srst_only separate srst_nogate srst_open_drain connect_assert_srst
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : Unable to match requested speed 2000 kHz, using 1800 kHz
Info : clock speed 1800 kHz
Error: libusb_open() failed with LIBUSB_ERROR_NOT_SUPPORTED
Info : STLINK v2 JTAG v28 API v2 M v18 VID 0x0483 PID 0x374B
Info : using stlink api v2
Info : Target voltage: 3.258614
Error: init mode failed (unable to connect to the target)
in procedure ‘program’
in procedure ‘init’ called at file “embedded:startup.tcl”, line 473
in procedure ‘ocd_bouncer’
- OpenOCD init failed **
shutdown command invoked
;){kind=link}