Loading...
 

System Workbench for STM32


You are viewing a reply to problem with target programming  

run project

hello,
I can compile a project, but when I run it I get the message bellow, is it normal?
thank

Open On-Chip Debugger 0.10.0-dev-00011-g46c94c8 (2018-09-06-08:44)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
srst_only separate srst_nogate srst_open_drain connect_assert_srst
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter_nsrst_delay: 100
adapter speed: 240 kHz
Info : clock speed 240 kHz
Info : STLINK v2.1 JTAG v28 API v2 M17 VID 0x0483 PID 0x374B
Info : using stlink api v2
Info : Target voltage: 3.283124
Info : Stlink adapter speed set to 240 kHz
Info : STM32L152RETx.cpu: hardware has 6 breakpoints, 4 watchpoints
Info : Stlink adapter speed set to 240 kHz
adapter speed: 240 kHz
target halted due to debug-request, current mode: Thread
xPSR: 0x01000000 pc: 0x08000230 msp: 0x20014000
STM32L: Enabling HSI
Info : Stlink adapter speed set to 4000 kHz
adapter speed: 4000 kHz

    • Programming Started **

auto erase enabled
Info : Device: STM32L1xx (Cat.5/Cat.6)
Info : STM32L flash has dual banks. Bank (0) size is 256kb, base address is 0x8000000
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000000e msp: 0x20014000
wrote 4096 bytes from file Debug/test.elf in 0.228703s (17.490 KiB/s)

    • Programming Finished **
    • Verify Started **

target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000002e msp: 0x20014000
target halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x2000002e msp: 0x20014000
verified 2100 bytes in 0.034671s (59.150 KiB/s)

    • Verified OK **
    • Resetting Target **

Info : Stlink adapter speed set to 240 kHz
adapter speed: 240 kHz
shutdown command invoked