Problems with System Workbench
Hi Felix,
I collected the steps to reset my target, in the following topic :
http://www.openstm32.org/forumthread823
Here is the procedure :
- first halt the application,
- then select the Console window (typically located at the bottom of the Eclipse UI),
- then enter this command in the Console window: monitor reset halt
This will reset the target and stop the application at the very first instruction,
which is usually the startup assembly code.
Note that the source level debugger display will NOT update automatically after issuing the reset command. However, if you hit one of the single-step buttons (e.g. F6, Step Over) the source debug display will update.
You will then probably want to switch the debug display to your main()
and either highlight the first code line of main() and hit Ctrl-R (Run To Line) or set a breakpoint on it and hit F8 (Resume).
From this point, I am able to debug again my application normally.