Loading...
 

System Workbench for STM32


Create script failure: fail to retrieve target

Hello,

I have created project using STM32 Cube MX. I have specifically selected Nucleo F7 46ZGx board. I have configure whatever was required and generated the code. Then I open Workbench(Eclipse) and imported the project which was created by CubeMx. I have set up Build target in properties of project under C/C++ Build > setting >Target. Pressed “Apply” and then “Ok”. I build my project and it was successful. Now I want to run and debug it hence I tried to configure debugger but in Debugger configuration, Target mcu and board in blank. Please refer attachment. whenever I open Run configuration, I always get error “Create script failure: fail to retrieve target”. could you please tell me where I did mistake. If information is not sufficient then please let me know.